How do you join the chain

When the chain is first produced, it is usually a section, and it is connected to become a long chain.

1.Prepare all the hand things of the pin, chain piece, cotter pin and dip chain, labor guarantee completely, wear braided chain and wear lisle.

2. First of all, the two ends of the chain are separated from the automatic, forced sprocket, hung up, and then take out the twine, the end of the rope from the bottom up through the second chain section of the chain, and then the pressure rope is tied.

Take the other rope head from the bottom to the eight-figure chain through the second chain link at the other end of the same chain, and then go around the chain link from the top down through the third chain link (the same chain), the rope around the chain link, and then from the bottom up through the third chain link at the other end (different rehearsals), the two ends of the chain are connected in series. The rope should not be too much, usually three, to avoid difficult to tie the chain.

Pull the twine tightly so that the two ends of the chain are joined together.

The chain adapter occludes it at both ends of the chain, and adjusts the adjusting screw of the chain adapter to make the first chain link at both ends of the chain butt together.

Take the chain pin and stab it into the sleeve of the first chain link at both ends of the chain, align the inner piece of the chain, and align the connection of the other row, and then drive the chain pin evenly into the inner chain piece and the sleeve with a hand hammer, install the outer piece, and put on the cotter pin.

After the chain is connected, take off the chain connector, put it away, and then untie the twine and clean up the operating area.